AnyTone AT-588UV, Руководство пользователя

Страница: 35 / 43

29
8
Microphone Operation
Send dtMF SiGnAlinG
MAin/Sub bAnd SwitchinG
Function opeRAtion thRouGh pA-pd keYS
You can operate the transceiver by keypad or input desired frequency
and channel through the QHM-04 microphone.
Hold the PTT key; input the desired DTMF signaling by the numeric keys.
This transceiver is defaulted on dual receive, in this status, a
MAIN icon will displayed in the top right corner of the Main band
frequency,transmitting only available on the Main band. In standby, you
can switch Main band and sub band by the A/B key.
PTT
Main/Sub band switch
UP
DOWN
MIC
Numeric Keys
This function is valid only when current channel set with offset frequency.
PRI
：
LOW : Output power setup, in standby, press the key programmed as
as LOW function will change the lower level.When LCD displays HIGH,
the transmitting power on current channel is high. When LCD displays
MID1, the transmitting power on current channel is middle1, When LCD
displays MID2, the transmitting power on current channel is middle 2.
When LCD displays LOW, the transmitting
power on current channel is low.
TONE : CTCSS/DCS code setup. In standby, press the key
programmed as TONE function will able to setup CTCSS/DCS code.
when the LCD key to choose CTCSS encode. When the LCD displays
"ENC","DEC" and CTCSS frequency,press the microphone [ UP/DOWN ]
key to choose CTCSS decode. When the LCD displays "DCS" and DCS
code,press microphone displays "ENC" and CTCSS frequency, press the
microphone [ UP/DOWN ] key to choose DCS
code.
MHZ : In VFO mode, press the key programmed as MHZ function,
the megabit digital in the LCD flashes, now turn the channel know or
microphone [ UP/DOWN ] key to adjust frequency by 1Mhz step. In
channel mode, press this key, the channel number flashes, now adjust
selector knob or microphone [ UP/DOWN ] key
to adjust channel.
The PA,PB,PC,PD, keys are programmable, they can be endowed with
the following functions.
RPTR: OFFSET direction setup, in standby,
press the key programmed as RPTR function
will change the offset direction. when LCD displays"+", means plus offset,
when the LCD displays"-", means minus offset.
NOTE