AnyTone AT-588, Руководство пользователя

Страница: 17 / 43

12
In standby, press key or Microphone's
key until appear , this indicates current
channel in channel mode. Repeat above
6
PWR KEY
Dial
Frequency
decrease
Frequency
increase
Volume Knob
Min
Volume
Max
Volume
Basic Operations
Switching The Power On/Off
Adjusting The Volume
Switch between VFO and Channel mode
Adjusting Frequency/Channel THROUGH SELECTOR KNOB
Receiving
according to the option selected during
installation Press the switch or turn the
ignition key to ACC (speed up) or ON (startup)
position to power on radio . Press the key
for 1s or turn the ignition key to OFF position
to turn off.
When the channel you are operating is
called, the screen shows and field
intensity, in this way, you can hear the calling
from transmitting party.
Under frequency (VFO) mode, you can
1.
change the current frequency to the
desired one through selector knob; Turn
clockwise to increase frequency; turn
counterclockwise to decrease. Every
gear will increase or decrease one step.
Press
key, the decimal point of
Turn the VOL knob clockwise to increase
the audio level, counterclockwise to decrease.
During communication, volume can be adjusted more accurate.
5k, 6.25k, 8.33K,10k, 12.5k, 20k, 25k, 30k and 50k total nine step size
available for this radio.
If the transceiver has set at higher squelch level, it may fail to hear the calling.
operation to switch between Frequency mode
(VFO) and Channel mode.
frequency in screen will be auto-hidden. In this status, turn selector
knob or Microphone [
/ ] key will increase or decrease
frequency quickly by 1MHz step .
Under channel mode, you can change the current channel to the
2.
desired one through selector knob, clockwise turn to the forward
channel, anticlockwise turn to the backward channel. In relative
working mode, Microphone's [
/ ] key has same
function for adjusting frequency and channel.
Transmitting
Press and hold key or press MIC's key to monitor for a while
WRFRQ¿UPWKHFKDQQHOGHVLUHGLVQRWEXV\ Release or press Mic's
key to return standby status,Then press and hold [PTT] key to speak
into microphone.
When the channel you are operating is called,the screen shows BUSY
and field intensity,you can't hear the calling from transmitting party,it
means current channel receives a matching carrier but unmatching
signaling(Refer to CTCSS/DCS encode and decode or Optional Signaling
setup).