Anybus HMSI-27-201, Руководство по установке, Страница: 9 / 12

Example 2: Single Clients 9 (12)
5 Example 2: Single Clients
This example describes two Ethernet devices connecting via two Wireless
Bridges in Single Client mode over an ad-hoc network.
Single Client mode has higher performance than UDP Tunneling since no encap-
sulation of the Ethernet packages is required. Only one Ethernet device can be
connected to each Wireless Bridge.
1. Reset both Wireless Bridges to the factory default settings using SMART
configuration mode 2 (LED B).
2. On the first Wireless Bridge, activate SMART configuration mode 4 (LED C).
The LED will blink while the unit is waiting for a connection.
3. On the second Wireless Bridge, activate SMART configuration mode 5
(LED A+C). The LEDs will blink until the units have connected.
4. When the Wireless Bridges have established a connection, activate SMART
configuration mode 11 (LED A+B+D) on the first unit.
5. Activate SMART configuration mode 11 on the second Wireless Bridge. The
LEDs will blink while the unit enters client mode and retrieves the MAC ad-
dress of the other unit.
6. The first unit will now have IP address 192.168.0.98 and the second
192.168.0.99. The units will be operating in ad-hoc mode.
For more use cases and advanced configuration examples, see the Anybus
Wireless Bridge User Manual available at www.anybus.com/support .
Anybus ® Wireless Bridge Installation Guide HMSI-27-201 SP2107 2.2