Anybus HMSI-27-201, Руководство по установке, Страница: 6 / 12

Configuration 6 (12)
3 Configuration
SMART Configuration Modes
The most common configurations can be set up quickly by using the MODE but-
ton and the A-B-C-D LEDs to select one of the SMART modes.
1. Power on the Wireless Bridge, then immediately press and release MODE .
2. Press MODE repeatedly to cycle through the configuration modes until the
desired mode is indicated.
3. Press and hold MODE until the LEDs go out or blink, then release it. The unit
will restart in the selected configuration mode.
If the unit is not restarted within 20 seconds of selecting a configuration
mode it will exit SMART configuration and return to the previous settings.
Ad-hoc WLAN devices are connecting directly to each other.
Maximum throughput = 11 Mbit/s.
Infrastructure WLAN devices are connecting via an access point.
Maximum throughput = 14 Mbit/s.
Single Client The Wireless Bridge acts as a wireless interface for the
Ethernet device it is connected to, and will clone its MAC
address. This means that only one Ethernet device can be
connected to each Wireless Bridge.
Multiclient Same as Single Client mode but allowing multiple devices
to communicate on the IP layer.
UDP Tunnel Ethernet packages are encapsulated in UDP packages and
transferred transparently between two units.
This mode has significantly lower throughput than the Sin-
gle Client and Multiclient modes.
Anybus ® Wireless Bridge Installation Guide HMSI-27-201 SP2107 2.2