VERTICAL CONTACT TOASTER
8
P/N 1010838 Rev. D 07/06
Burger King
NOTE: The toaster is tested and shipped with the heaters
set at the above recommended temperatures.
OPERATION
THICKNESS
THICKNESS
2 = 5/8" (15.9mm)
3 = 11/16" (17.5mm)
4 = 3/4" (19.0mm)
5 = 13/16" (20.6mm)
6 = 7/8" (22.2mm)
1 = 1/2" (12.7mm)
B = 3/4" (19.0mm)
F = 1"
(25.4mm)
D = 7/8" (22.2mm)
E = 15/16" (23.8mm)
C = 13/16" (20.6mm)
A = 5/8" (15.9mm)
Figure 3. Bun Thickness Adjustment Controls
Operating Instructions
1. Set the Bun Thickness Adjustment Controls
(Figure 3) to desired setting.
NOTE: Recommended settings are “2” for heel and
“D” for crown.
2. Turn the Rocker Switch (power On/Off) to ON.
(Figure 2). Allow the toaster to warm-up for 30
minutes before proceeding.
NOTE: The temperature display (Figure 2) will flash
“LO” until the toaster reaches its preset operating
temperature. When the toaster approaches the pre-
set temperature of 600°F (315°C), “USE” appears
in the temperature display and the unit is ready to
toast buns. If “USE” does not appear in the win-
dow after warm-up period of approximately 30 min-
utes, contact your Authorized Service Agency.
3. Drop Crowns into the front slot and Heels into
the rear slot (Figure 2).
Cut sides of heel and
crown must face each other.
4. Toasted buns will drop into the bun landing area
(Figure 2). Heels toast in approximately 8 sec-
onds and Crowns toast in approximately 12 sec-
onds.
5. Test at least 4 buns before putting the toaster into
service.
6. Turn the Rocker Switch (power On/Off) OFF
when finished toasting for the day and pro-
ceed with the
daily cleaning
as outlined in the
Maintenance section of this manual.
Temperature Adjustments
The VCT-2000 uses a Platen Heater and two Auxiliary
Air Heaters. The Platen Heater consists of a heating
element built into the Platen to toast the cut side of
the bun. The two Auxiliary Heaters assist in provid-
ing additional heat to the buns. The first Auxiliary Air
Heater is located between the conveyor in the front of
the toaster. The second Auxiliary Heater is located
between the conveyor at the rear of the unit.
RECOMMENDED TEMPERATURES
Recommended temperature setting for the platen heat-
er is 600°F (315°C).
Recommended temperature setting for the auxiliary
heaters is 400°F (204°C).
1
2
4
5 1 = 1/2"(12.7mm)
2 =
5/8"(15.9mm)
3 = 11/16"(17.5mm)
6 =
7/8"(22.2mm)
THICKNESS
THICKNESS
1
2
3
4
6
6
5
4 =
3/4"(19.1mm)
5 = 13/16"(20.6mm)
3
Bun Thickness
Adjustment Control
(See Figure 3)
Bun Landing Area
Rocker
Switch
Temperature
Controls
& Temperature
Display
Hi-Limit
Reset
Power
Cord
Figure 2. VCT-2000 Toaster
Heels
Crowns
