MANUAL EGG COOKER/STEAMER
6
P/N 1011407 Rev. D 03/18
McDonald’s
Unpacking
1. Remove unit and all packing materials from
shipping carton.
NOTE: If any parts are missing or damaged, con-
tact Antunes Customer Service IMMEDIATELY at
+1-877-392-7856 (toll free).
2. Remove information packet.
3. Remove all packing materials and protective
coverings from the unit.
4. Wipe all surfaces of the unit with a hot damp
cloth.
NOTE: Do NOT use a dripping wet cloth. Wring it
out before use.
5. Clean the Egg Rings, Egg Racks, Top Covers,
and Scrap Pans in hot, soapy water. Rinse in
clear water and allow to air dry.
6. Reassemble all parts to unit.
INSTALLATION
IMPORTANT
Failure to level the unit may result in unevenly
cooked product.
Figure 1. Timer Controls
Leveling the Unit
The unit must be placed on a level surface. The unit
comes with 4 individually adjustable legs to assist in
leveling. Be sure to place the unit on a sturdy flat sur-
face and adjust the legs as needed to ensure the unit
is level. Turn legs
clockwise to shorten
or
counter-
clockwise to lengthen
.
To verify if the unit is level, use a level (if available).
If a level is not available, open the Top Cover and
Egg Rack and pour a small amount of water directly
onto the cool grill surface. If the unit is level, the water
should pool in the middle and not drain toward a certain
section of the unit. Make adjustments as required.
Turn Leg
Clockwise
to shorten.
Turn Leg
Counter-clockwise
to lengthen.
Timer Interface
Refer to Figure 1 to become familiar with the Timer
interface. The timer has two timing channels, one for the
front of the MES-1200 and one for the back.
Each timing channel has the following buttons set to the
default times shown:
• Round Front - 2 minutes 30 seconds
• Round Rear - 2 minutes 40 seconds
• Folded Front and Rear - 1 minute 45 seconds
• Time 3 Front - 2 minutes 30 seconds
• Time 3 Rear - 2 minutes 40 seconds
• Time 4 Front and Rear - 2 minutes
Pivot Rod
Front Egg Rack
and Rings
Rear Egg Rack
and Rings
Rear Top
Cover
Front Top
Cover
Timer
Grill
Surface
Figure 2. Components