MANUAL EGG COOKER/STEAMER
9
P/N 1011407 Rev. D 03/18
McDonald’s
PROGRAMMING
Figure 3. Timer Controls
Programming Timers
Pressing the Program Button causes
ADJ
to appear on
the display. Press the Program button again to change
the Beep setting of the timer. Use the
Up
and
Down
ar-
row buttons to select from the three Beep settings:
1. Beep 1 - Standard
2. Beep 2 - Loud
3. Beep 3 - Intermittent
Changes are saved after 5 seconds of inactivity. You
can also press the Program button to save changes.
This Switches to the Battery Level view, showing the
percentage of battery power remaining.
To program a button with a specific time:
1. Press the Program button.
ADJ
appears on the
display.
2. Press the desired button to change (Round,
Folded, Time 3 or Time 4).
3. Use the
Up
and
Down
arrow buttons to scroll to
the desired time. Pressing and holding an arrow
button will cause it to move faster in that direction.
4. Changes are saved after 5 seconds of inactivity.
Batteries
The Timer uses 4 AA Alkaline Batteries. To access the
battery compartment:
1. Remove the timer from the bracket.
2. Use a Phillips head screw driver to remove the 6
Phillips head screws on the rear of the timer.
3. Remove the back housing from the timer. The
batteries are secured inside the timer with Velcro.
Carefully remove and replace the batteries and
secure inside the Timer.
4. Reattach the back panel and secure with the 6
screws.
Depending on the BEEP setting, the batteries should
last approximately:
• 2 + years using BEEP setting 1
• 2 years using BEEP Setting 2
• Less than 2 years using BEEP setting 3
The timer displays
LO BATT
when the batteries are
low on power and the batteries require changing. If the
timer displays are blank, check the LED sensor on the
back of the timer for obstructions. If the LED sensor is
not obstructed and the displays are blank, the batteries
have lost all power and must be replaced.
Display Bracket
The Timer comes with a Display Bracket to allow you to
place labels for the Timer 3 and Timer 4 buttons. To ac-
cess the Display Bracket:
1.
Remove the flat head screw from the right side of
the Timer (facing the timer) and slide the bracket
out.
2.
Affix labels to the Display Bracket as desired.
3. Reinsert the Display Bracket into the Timer and
secure with the screw.
START/STOP
POWER
2'-00"
2'-30"
READY
COOKING
BACON
1
2
MES-1200 Setpoint Temperature
The MES-1200 is pre-programmed to operate at a set-
point temperature of 285
°
F. If the temperature needs to
be reset to the preset temperature:
START/STOP
POWER
2'-00"
2'-30"
READY
COOKING
BACON
1
2
F. Press the
START/STOP
button to exit program
mode and save the new setpoint temperature.
ON
OFF
OFF
A. If installed, remove the Timer from the front of the
MES-1200 unit.
B. On the MES-1200, plug in the power cord and turn
the unit on.
C. Press and hold the
1
button,
2
button, and the
START/STOP
button together for approximately 5
seconds.
D. The
1
and
2
button LEDs will blink once a second
and continue to blink for as long as the MES-1200
is in temperature program mode.
E. Press the
1
or
2
button until the Ready LED is ON
and the Bacon and Cooking LEDs are OFF. This
changes the setpoint to 285
°
F.
