7
P/N 1011443 Rev. C 08/17
DAILY CLEANING
Clean the Toaster and Belt Wraps
1. Press the Power button to turn
the unit off. The unit enters a cool
down mode and the belts continue
to turn. The toaster automatically
shuts down when complete.
NOTE:
You do not need to wait for the
unit to shut down to perform
these steps.
2. Wearing Heat-resistant gloves, Re-
move the bun feeder, top cover, and
the front and rear conveyor covers
(Figure 5).
3. See Figures 6 - 9. Inspect the front
belt for any tears, discoloration, or
damage to the Belt Wrap snaps.
Replace any damaged Belt Wrap as
needed. With proper maintenance
the Crown and Main Belt Wraps can
six months or longer.
4. If the front belt is in good condi-
tion, spray a clean, sanitizer-soaked
towel Sink Detergent solution. Wipe
the front belt clean. Rinse the front
belt with a separate clean, sanitizer-
soaked towel. Allow to air dry.
NOTE:
The belt rollers continue turning
while in cool-down mode. This
allows you to clean the entire
belt. Only clean the belt where
it is in front of the Backing Plate
- between the support rods - to
avoid causing damage to the
belt. Repeat this step several
times if there is heavy carbon
buildup on the conveyor belt.
5. See Figures 6 - 9. Inspect the rear
belts for any tears, discoloration,
or damage to the Belt Wrap snaps.
Replace any damaged Belt Wrap as
needed. With proper maintenance
the Crown and Main Belt Wraps can
six months or longer.
6. If the rear belt is in good condi-
tion, spray a clean, sanitizer-soaked
towel with Sink Detergent solution.
Wipe the rear belt clean. Rinse the
rear belt with a separate clean,
sanitizer-soaked towel. Allow to air
dry.
NOTE:
The belt rollers continue turning
while in cool-down mode. This
allows you to the entire belt.
NOTE:
Only clean the belt where it is
in front of the Backing Plate to
avoid causing damage to the
belt.
7. Wash, rinse, and sanitize the bun
feeder and top cover in the three-
compartment sink.
8. Wash, rinse, and sanitize the front
and rear conveyor covers in the
three-compartment sink.
9. Reinstall the clean front and rear
conveyor covers, top cover, and bun
feeder (Figure 5).
10. Clean the outside surfaces of the
toaster with clean, sanitizer-soaked
towel sprayed with Heavy Duty
Degreaser Solution. Rinse with a
clean, sanitizer soaked towel and
allow to air dry.
11. Turn the unit on.
12. Place all used towels into the soiled
towel bucket.
Figure 6. - Examples of Damaged Belt Wraps
BUN FEEDER
TOP COVER
REAR
CONVEYOR
COVER
REAR
CONVEYOR
COVER
Figure 5. - Removing Components
SUPPORT
RODS
