5
P/N 1011443 Rev. C 08/17
INSTALLATION
1. Remove unit and all packing mate-
rials from shipping carton.
NOTE:
If any parts are missing or dam-
aged, contact Antunes Cus-
tomer Service IMMEDIATELY at
+1-877-392-7856 (toll free).
2. Remove all packing materials and
protective coverings from the unit.
3. Wipe the entire exterior of the
toaster and the accessories men-
tioned above with a hot damp
cloth. Allow to air dry
NOTE:
Do NOT use a dripping wet
cloth. Wring out before use.
4. Attach the top cover and bun
feeder (Figure 3).
5. Set the Compression Knobs to
the desired setting (Figure 1). The
recommended Compression Set-
tings are:
CROWN - #4
HEEL - #3
6. Plug the power cord into the ap-
propriate power outlet. Refer to the
specification plate for the proper
voltage.
When placing the toaster into ser-
vice, pay attention to the following
guidelines.
• Make sure the power switch
is off and the unit is at room
temperature before plugging in
the power cord.
• Do not block or cover any open-
ings on the unit.
• Do not immerse the power cord
or plug in water.
• Keep the power cord away from
heated surfaces.
• Do not allow the power cord
to hang over edge of table or
counter.
• Place the unit on a sturdy, level
table or other work surface.
• Turn the power switch to off (if it
is set to on).
• Ensure the line voltage cor-
responds to the stated voltage
on the specification label and
power cord warning tag.
Figure 1. GST-2V Toaster
OPERATION
1. Press and release the Power button
to turn the toaster on. Allow the
toaster to warm up until USE ap-
pears in the display. See Figure 2.
2. Set the Compression Knobs to the
desired setting. The recommended
Compression Settings are:
CROWN - #4
HEEL - #3
3. Insert product into the appropriate
lane on the Bun Feeder according
to Bun Feeder labels. Insert buns
with the cut side towards the inside
of the toaster.
4. Finished product drops onto the
heated bun landing zone.
Light/Dark Adjustments
The light/dark value (Figure 2) can be
adjusted when the unit is displaying USE.
To adjust the light/dark value:
1. Press the LIGHTER or DARKER but-
ton. The display changes to show
the current light/dark value.
NOTE:
The default setting is d0.
2. Press the LIGHTER or DARKER
buttons to change the light/dark
value. The adjustment range is L1-
L9 and d0-d9. L9 is the lightest, d0
is the middle, and d9 is the darkest
setting.
3. To save the light/dark value, wait 5
seconds until USE appears in the
display.
NOTE:
Adjusting the light/dark value
changes the speed of the con-
veyors - it does NOT change the
temperature. The light/dark
value resets to the default value
of d0 when the unit is turned off.
TOP COVER
BUN FEEDER
FRONT
CONVEYOR
COVER
REAR
CONVEYOR
COVER
Figure 3. Components
HEATED BUN LANDING ZONE
CONTROL
PANEL
SIDE DOOR
COMPRESSION KNOB
(BOTH SIDES OF TOASTER)
PROGRAM
LIGHTER DARKER
s1 (877) 392-7854
POWER
BUTTON
(ON/OFF)
UNIT
DISPLAY
Figure 2. - GST-2V Control Panel
