Antunes Gold Standard GST-5V, Руководство пользователя

Страница: 9 / 24

9 P/N 1011263 Rev. D 04/18
Install Belt Wraps
1. If you are installing the existing belt
wraps, inspect the belts. Replace belt
wraps if worn or damaged. If the belt
wraps are in good condition, put
them back on the toaster.
2. For new or existing belts, wipe both
sides of the belts with a clean, damp
sanitized towel. Allow to air dry.
3.
Slide the belts gently over the appro-
priate top and bottom roller. Make
sure the belt lines up properly on the
rollers. The snaps on the belts should
face the inside of the roller.
4.
Lift up both the top rollers. Use both
hands. This will add tension and lock
them in place.
5. Lift the lower conveyor lock to lock
the rollers into place.
NOTE: Lift up on the camshaft of the rear
conveyor roller wile lifting the
lower conveyor lock.
6. Lift the upper belt frame lock and
lock in place on the conveyor as-
sembly. Set the compression knobs
to their original settings.
7. Close the side panel and lock the
lock using a flat-headed screwdriver.
8.
Reinstall the conveyor covers and
bun feeder.
9. Plug the power cord into the appro-
priate outlet and turn the unit on.
ANNUAL CLEANING
Cleaning the Top Cooling Fan and
Electrical Housing
Follow these steps to clean the top fan.
1.
Turn the power switch to the OFF
position. The toaster enters a cool-
down mode and will automatically
shut down when complete. Unplug
the power cord.
2.
Remove the optional Top Feeder (if
Present). Remove the Bun Feeder.
3. Facing the front of the toaster, move
to the right Side Panel. Remove the
2 top screws from the right Side side
Panel and lower the panel (Figure
16).
4. Use a plastic brush or similar tool to
brush all 5 fan blades from beneath.
Be sure to remove all debris.
Figure 6. Accessing Top Cooling Fan
Figure 7. Accessing Rear Cooling Fan
5. Carefully clean any debris from the
inside floor of the control compart-
ment and from all electrical connec-
tions. Be sure to remove any grease,
lint, or debris from these areas.
6. Attach the right Side Panel and
secure with screws.
7.
Resasemble the unit.
Cleaning the Rear Cooling Fan
and Electrical Housing
Follow these steps to clean the rear fan.
1.
With the unit off, remove the 3 rear
screws securing the rear access panel
and carefully lower the panel (Figure
17).
2. Use a plastic brush or similar tool to
brush all 5 fan blades free of debris.
3.
Carefully clean any debris from the
floor of the toaster and from all elec-
trical connections. Be sure to remove
any grease, lint, or debris from these
areas.
4.
Attach the rear panel and secure
with the 3 screws.
NOTE: Be careful not to pinch wiring
upon closing the rear panel.
5.
Plug in the power cord, turn the
power switch on, and test the toaster
for proper operation.