Antunes Gold Standard GST-5V, Руководство пользователя

Страница: 8 / 24

8 P/N 1011263 Rev. D 04/18
QUARTERLY CLEANING
Remove Belt Wraps & Clean Roll-
ers
1.
Turn the toaster’s power switch to
the off position. The toaster enters a
cool-down mode and will automati-
cally shut down when complete.
2. Unplug the power cord once the
cool-down period is complete.
NOTE: Wait for the cool-down period to
complete before unplugging the
power cord.
3. Remove the bun feeder using heat-
resistant gloves.
4.
Remove the front and rear conveyor
covers by lifting up and away from
the unit. Set the compression knob
to 7.
NOTE: Reposition the toaster as needed
to perform these steps.
5. Unlock the lock on the left side panel
with a flathead screwdriver and open
the panel. Set the bun compression
knob to 7.
6.
Push down on the front and rear belt
rollers and move them away from
the center of the toaster. Use both
hands. This removes tension and
locks the rollers in place. See Figure
3.
7. Lift the upper belt frame lock.
Then rotate down so it rests on the
camshaft of the rear belt roller. See
Figure 4.
8.
Pull down the lower belt frame lock
(Figure 4). This provides access to the
front and rear belt rollers and belts.
9. Carefully remove both of the belts
from the toaster (Figure 5).
10.
Wipe all four rollers and backing
plates with a clean, sanitizer-soaked
towel. Make sure to remove all debris
from the rollers and the backing
plates so they are as clean as pos-
sible.
11. Use a dry cloth towel or nylon-
bristled brush to remove all debris
from both side compartments, inside
of the toaster, and underneath the
rollers.
TENSE
TENSE
LOOSE
LOOSE
Figure 3. Conveyor Rollers
Figure 4. Conveyor Locks
Figure 5. Remove and Discard the Belts
DO NOT REUSE THE BELTS!
LOWER BELT FRAME
LOCK
UPPER BELT FRAME
LOCK
CROWN BELT
WRAP
CLUB/HEEL
BELT WRAP
CROWN
BELT WRAP
MAIN
BELT WRAP