UFL-500 SERIES
8
P/N 1012043 Rev B 11/19
®
Unpacking
1.
Open the large box. It should
contain:
A. Bracket mounted UFL system with
an UltraFilter Cartridge installed.
B. Padded envelope containing:
y
Power Adaptor
y
Owner’s Manual
y
Glove and Sticker Kit
2.
Remove all packing materials
and protective coverings from the
system.
3.
Remove the information packet. Fill
out and mail the
warranty card immediately to prevent
any delay in obtaining warranty
coverage.
NOTE:
If any parts are damaged,
contact Antunes IMMEDIATELY
at +1-877-392-7854.
Equipment Setup
General
When placing the system into service, pay attention to the following guidelines:
y
DO NOT immerse cord or power plug in water
y
Keep cord away from heated surfaces.
Electrical
The line voltage must match the voltage on the specification label. The plug on the
power cord must match the appropriate outlet. DO NOT connect the system to a
switched electrical outlet.
Plumbing
NOTE:
The system must be connected to the COLD water line. DO NOT connect
the system to the hot water line.
The UFL system uses the following connections:
System Inlet
3/4" FNPT
System Outlet
(Product Water)
3/4" FNPT
Drain
3/4" FNPT
When making a plumbing connection to the system, use a back-up wrench on the
supporting plumbing. Always use a quality, approved pipe sealant or thread seal tape
on pipe threads. DO NOT allow pipe sealant inside pipes.
DO NOT over tighten the connections. Use plastic fittings when connecting to the
plastic connections of the system.
If soldered plumbing is used, DO NOT apply heat to, or near, the filtration system. Use
union (O-Ring seal) connections for ease of installation and future servicing.
Suggested Tools and Supplies for Installation
The following tools and supplies are suggested to help with the installation:
y
Screwdriver
y
Adjustable Wrenches
y
Drill with Bits
y
Level
y
Tape Measure
y
Pipe Dope or Thread Seal Tape
y
Two Gallon Bucket
y
Hose or pipe for drain line
y
Pipe Wrenches
y
Fresh, Unscented
Liquid Chlorine Bleach
