Antunes 9210850, Руководство по эксплуатации

Страница: 12 / 24

HCT-5H BUN TOASTER
12
P/N 1011256 Rev. I 3/18
McDonald’s
TROUBLESHOOTING
WARNING
To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equip-
ment should be performed by qualified service personnel. The unit should be unplugged when servicing,
except when electrical tests are required.
If the troubleshooting steps listed do not solve your machine problem, contact an Authorized Service
Agency for further assistance or service.
Problem Possible Cause(s) Corrective Action
Display Reads
“Hi-Limit Tripped”
Either Hi-Limit A or B has tripped. Remove black cap & firmly press the green
buttons. Contact Antunes Technical Support at
+1-877-392-7854 (toll free) for assistance.
Display Reads
“Conveyor Stopped”
A Mechanical Obstruction has occurred
which completely stalled the conveyor
motor.
Check the conveyor belts & surrounding areas
for any obstructions/jams. Contact Antunes
Technical Support at +1-877-392-7854 (toll
free) for assistance.
Display Reads “Motor
Running Slow”
A Mechanical Obstruction has occurred
that is slowing down the conveyor motor.
Display Reads “Motor
Slow”
Display Reads “Motor
Load”
Display Reads
“Control Temperature
Fail
Toaster Electrical compartment is over-
heating due to Lack of airflow surround-
ing the toaster.
Inspect the cooling fan on the side for opera-
tion & ensure it is clean. Contact Antunes
Technical Support at +1-877-392-7854 (toll
free) for assistance.
Display Reads “Motor
Temperature Fail”
Display Reads
“Internal Fault”
Control Board Malfunction. Cycle Power OFF/ON. If message persists,
then contact Antunes Technical Support at
+1-877-392-7854 (toll free) for assistance.
Display Reads
“Internal Error”
Display Reads
“Overtemp A”
Platen A heater is overheating & exceed-
ed its set-point.
Display Reads “SSR
A Fail”
The solid state relay for Platen A has
failed.
Display Reads
“System A Fail”
The Platen Heater A heater did not reach
set-point temperature.
Display Reads “Platen
A Low”
The Platen heater A heater has dropped
below the set-point temperature after
achieving set-point but cannot recover.