Antunes 9210850, Руководство по эксплуатации

Страница: 11 / 24

HCT-5H BUN TOASTER
11 P/N 1011256 Rev. I 3/18
McDonald’s
MAINTENANCE (continued)
INSTALLING BELTS
1. Follow the steps for
Removing Belts
.
2. Wipe both sides of the new Belts with a clean,
sanitized towel sprayed with an approved sanitizer
and allow to air dry.
3.
CLEAN ROLLERS:
Wipe all four rollers with a
clean towel sprayed with sanitizer. Make sure to
remove all debris from the rollers so they are as
clean as possible.
NOTE: It is VERY important to clean all four rollers
whenever the belts are removed or replaced.
4. Slide the new Top Belt gently over the top rollers.
NOTE: Make sure the belt lines up properly on the
rollers. The snaps on the belts should face the
inside of the top rollers.
5. Slide the first crown belt over the rear top roller
and rear bottom roller. Repeat this step for the
club/ heel belt and the second crown belt.
NOTE: Make sure the belt lines up properly on the
rollers. The snaps on the belts should face the
inside of the bottom rollers.
6. Return the Top and Bottom Belt Rollers to full ten-
sion:
• Pull the Top Roller UP so it can slide out
towards the front of the toaster into operating
position.
• Push the Bottom Roller UP so it can slide out
towards the front of the toaster into operating
position.
7. Close the Belt Frame Lock firmly into place
(Figure 5) and press the latch in Figure 5 down.
8. Close and latch the Side Panel.
NOTE: Inform the Store Manager after any Belt
Replacement so new Belts can be ordered.
9. Set the Compression Knob to 4.
10. Re-install the Bun Feeder, Crumb Tray, and Bun
Buffer Frame.
11. Plug the power cord into the appropriate outlet.
Turn the toaster on.
Figure 4. HCT-5H Components
Bun Buffer Frame
Bun Feeder
Crumb Tray
Front Door