Anthony Liftgates ALB-1500, Инструкция по установке, эксплуатации и ремонту

Страница: 24 / 52

Anthony Lifgtates, Inc.
24
L-501 Models
www.anthonyliftgates.com 800-482-0003
4. When using the optional taillight kit, install the license
plate lights (1) in the provided holes in the left taillight
housing. Bolt the license plate bracket (2) to the left
taillight housing using the threaded holes.
5.
Place the rubber light gaskets in the openings
and seat over the edge of the housing.
6.
Press the lights into place and seat firmly.
Install the white backup lights in the inner two
openings.
6.3 Cable Lug Installation
1. Strip insulation one inch back from the end of the
cable to expose the copper wire.
T
YPE SGT
T
YPE SG
T
1"
ALI-00103
2. Position the cable lug on the exposed wire, as shown.
Crimp the cable lug using a cable crimping tool
(hydraulic or manual).
TYPE
SGT
TYP
E SGT
ALI-00104
NOTICE
Proper wire connections are crucial to the life of the
liftgate’s power unit. DO NOT crimp (smash) the cable lug
with a hammer to secure it to the cable. Poor connections
can result in low voltage, and any attempt to operate
below the minimum required voltage could cause system
failure.
3. Use the supplied heat shrink tube to insulate the new
connection. Heat the shrink tubing using a heat gun
or flame until it shrinks around the cable insulation
and cable lug, leaving only the mounting hole
exposed. Do not overheat the heat shrink tubing.
TYPE S
G
T
TYP
E
SGT
ALI-00105
6.4 Attaching the Power Cable to Truck Frame
There are several options for attaching the power cable
with the plastic fuse assembly. It can be fastened using
plastic tie wraps or wire clips. The fuse assembly can
also be bolted directly onto the body, if desired.