Anthony Liftgates ALB-1500, Инструкция по установке, эксплуатации и ремонту

Страница: 16 / 52

Anthony Lifgtates, Inc.
16
L-501 Models
www.anthonyliftgates.com 800-482-0003
14. Position the liftgate so the lower support bracket is
flush to the bed.
15. Using the holes in the lower support bracket as a
guide, drill 3/8” clearance holes through the bed.
16. Bolt the lower support bracket through the bed using
3/8”-16 x 1-3/4” bolts. Use the reinforcement plate
shown on page 11 under the washers and nuts on
the underside of the bed.
Tip: The reinforcement plate and/or the lower support
bracket may need to be cut to fi t some installations.
This is acceptable as long as at least two bolts
remain on each fl ange. If it is necessary to cut the
parts, use a rust preventive paint or cold galvanizing
compound to protect the exposed metal from rust.
WARNING
Always use a cutting torch in a
well ventilated area and, if in an
enclosed area, vent the fumes to
the outside. Breathing the smoke and fumes can
cause serious injury.
Always follow all State and Federal health and
safety laws and/or local regulations when using
a cutting torch. Also, follow all manufacturer’s
safety guidelines. If other people are present during
the installation of the liftgate, make sure they remain
clear of the cutting area.
To avoid eye injury, always wear eye protection
with the proper lens to protect your eyes.
Tip: There are two sets of mounting straps furnished,
of different sizes. Use the size that best fi ts your
installation.
17. Install the mounting straps and strap washers to the
liftgate post using 1/2-13 x 1” bolts. Do not tighten
the bolts yet.
18. Slide the mounting strap to the edge of the bed. Drill
through the holes in the mounting strap, through the
lip of the bed, and secure the mounting strap with
3/8-16 x 1-3/4” bolts. Tighten the bolts in the liftgate
post.