6. Decals
SAFETY
INSTRUCTIONS
To prevent possible injuries
due to improper operation,
make sure all decals are
attached to the liftgate and truck and are legible.
1. Attach decals 1, 2, 3, 4, and 5 to the truck body, as
shown. If the truck is a flatbed, place the decals as
close to the control switch as possible and still clearly
visible.
891
NOTICE
THIS LIFTGATE IS PROTECTED
WITH AN ELECTRICAL OVERLOAD
CIRCUIT PROTECTION DEVICE,
EITHER A CIRCUIT BREAKER, OR
A FUSE, AND IS LOCATED NEAR
THE POWER SUPPLY
A-150238
ATU-141
894
PERSONAL INJURY HAZARD
Operation may require user to stand on platform.
To prevent injury or death of operators or bystanders:
Read and follow operator/owner manual for safety,
operation, inspection, and maintenance instructions.
•
Do not place unstable or unsafe loads on platform.
•
Do not allow loads to extend over edge of platform.
•
Be aware of surroundings when operating liftgate.
•
Owner/operators must properly maintain liftgate.
•
Ensure footing is stable and stand away from edge
before raising or lowering platform.
•
Do not exceed capacity or use liftgate for anything
other than intended purpose.
•
Do not allow body parts to contact moving components.
•
WARNING
A-131115
03/2008
A-131020
MAXIMUM
CAPACITY
2000 lb.
1
2
3
4
5
2. Make sure factory-installed decals 6, 7, and 8 are
attached to the lift arms and platform.
892
A-150601
7
6
8
3. Make sure factory-installed decals 9, 10, 11, and 12
are installed on and inside the power unit and on the
adapter frame tube.
893
This hydraulic reservoir is
filled with Kendall Glacial Blu
hydraulic fluid. Use ONLY the
same or equivalent fluid.
A-131133
10 AMP FUSE & HOLDER
Protects against dead shorts
in this "control circuit".
If blown, pull "fuse holder
cap", replace fuse, replace
"cap". If fuse continues to
blow, contact a qualified
mechanic, "control circuit"
may be damaged.
A-131001
10 AM
P FUSE & HOLDER
Protects against dead shorts
in this "control circuit".
If blown, pull "fuse holder
cap", replace fuse, replace
"cap". If fuse continues to
blow, contact a qualifie
d
mechanic, "control circuit"
may be damaged.
12
9
10
11
Item
Part
Number
Description
1
A-150238 Notice - Protected With Electrical Overload Circuit
Breaker
2
ATU-141
After Using Liftgate
3
A-131023 Operating Instructions
4
A-131115 Warning, Personal Injury
5
ATU-145
A-131020
ATU-174
1600 Lb. Maximum Capacity
2000 Lb. Maximum Capacity
2500 Lb. Maximum Capacity
6*
A-131034 Anthony Label
7*
A-131017 Note - Disengage Latch
8*
A-150601 Made In The USA
9*
A-131028 Weld Warning
10* A-131133 Hydraulic Fluid
11* A-131001 10 Amp Fuse Changing Procedure (attached to
control wiring in pump box)
12* A-131125 Warning, Galvanized Fumes Hazard (galvanized
models only)
*Factory Installed – Installer must make sure all decals are attached, as
shown.
1 — A-150238
2 — ATU-141
