7. Mono Button
Changes the current output that is selected by the Main Rotary Control from Stereo to Mono.
8. Antelope Button
Press the Antelope button & Mono button to enter touchscreen calibration mode.
9. Mute Button
Mutes the output currently selected by the Main Rotary Control.
Note: Press and hold the Mono Mute button before powering on the device for Factory Reset.
10. Headphone Outputs
Two independently assignable headphone outputs, selectable and controllable via the main volume
control knob. The lights next to the outputs are illuminated to indicate which headphone output is
currently controlled.
4. Rear Panel Explained
11. Mains Power Connector
The IEC connector supports a range between ~95-245V. This lets the device automatically
accommodate the mains voltage in each country.
12. Word Clock Input (also used for HDX Loop Sync)
BNC input used to accept Word Clock reference signal.
13. 10M Input
BNC Input Connector for receiving timing reference from an Atomic Clock, such as the Antelope
Audio 10M and 10MX. Useful for raising the oscillator accuracy even higher.
