5
CAUTION
Do not climb on the unit or try to move it when
installed.
Do not climb on the unit or try to move it when
installed.
Never introduce a stick, your finger or others in
the air inlet/outlet. The ventilator runs at high
speed: that would cause a very serious incident.
Important:
Well clean the plug
If dirtiness adheres to the plug or if it is badly
inserted: that can cause a fire or electric shocks.
If an abnormality (smell of burning…) occurs,
stop the unit, unplug or switch off the
electricity.
Do not clean the appliance with water.
Water will go into the unit and will destroy the
insulation.
Do not connect / unconnect the unit when
running ; press before all the button OFF.
Do not draw on the power supply cable. Well
have in hand the plug to disconnect it. Fire
hazard could occur due to the wrenching of the
electric cable.
Do not touch the plug with wet hands. It will
caused an electric shock.
By stormy weather, cut off the pump to avoid
the damaged caused by the lightning.
First off all the heat pump is stopped, put out
leaves or others little particles blocking the air
inlet vanes.
Verify the compatibility of the network with the data written on the heat pump before beginning
the installation.
The other disinfection systems such as electrolysis, chemical… are not recommended for a good
running of the pump. The pump must be r before these systems.
For an optimal running of the heating pump, many rules must been respected:
A. Use of free chlorine : max : 2.6mg/l
B. Total bromine : max : 5.6mg/l
C. pH : between 6.5 et 8.
