Antec Signature S10, Руководство пользователя

Страница: 14 / 184

14 S10 User Manual rev 1C
2.7 2.5” Solid State Drive Installation
There are a total of eight 2.5” SSD drive bays in the S10. Five drive bays are located inside the Power Supply Chamber
and three SSD drive bays are inside the Hard Disk Drive Chamber parallel to the 3.5” HDD drive bays.
Inside the Hard Disk Drive Chamber
1. Swing open the HDD tray door. The 2.5” SSD bay is to the right of each row of HDD drive bays (figure 22).
2. Slide the 2.5” SSD drive into the bay. You don’t need a Tray to hold the drive (figure 23).
NOTE: There are no silicone guides inside the SDD drive bay
3. Close the HDD tray door to secure the drive (figure 24).
4. Repeat the same procedure for the other drives as necessary.
5. Find an appropriate connector (SATA) on your power supply and connect it to the hard drive.
6. Connect the hard disk with a data cable (SATA) to the motherboard board.
Inside the Power Supply Chamber
1. Pull down the SSD tray door. You will see five 2.5” SSD bays inside (figure 25).
2. Slide the 2.5” SSD drive into the bay. You do not need a tray to hold the drive (figure 26).
NOTE: There are no silicone guides inside the bay
3. Close the SDD tray door to secure the drive (figure 27).
4. Repeat the same procedure for the other drives as necessary.
5. Find an appropriate connector (SATA) on the power supply and connect it to the hard drive.
6. Connect the hard disk with a data cable (SATA) to the motherboard.
Figure 22 Figure 23 Figure 24
Figure 25
Figure 26
Figure 27