Antal XT66/AL, Руководство по установке и обслуживанию

Страница: 9 / 12

9
MAINTENANCE SEQUENCE
Perform the following operations on a
work bench
Remove the two half rings at the top
of the center rod.
Pay attention to the center rod
because it is free to slip off the base
Unscrew the 3 screws on the base
and lift the base-stem block.
Clean the old lubricant from the roller
bearings; check the well-being of the
stem where the bearings slide; clean
the screw-holes on the base, the
screws and the washers.
(When re-mounting, it will be
necessary to put new grease on all
these parts, including the screws’
threads.
The Antal Hydrolub Grease also
serves the function of protection of
the aluminum from the risk of galvanic
corrosion.)
Now, simply remove the center rod.
Clean the old lubricant from all parts.
Lift the roller bearings, the spacers (in
case of presence) and the washers.
Carefully clean all these parts with a
soft bristle brush and solvent.
The cleaning of the gear section
and of the gears at the base of the
center rod does not require further
dismanteling.
It will be enough to use a soft bristle
brush and solvent.
1
3
2
1
2
3