Antaira Technologies - Industrial Ethernet Switches
LNX-2012G-SFP Series User Manual V1.0
62
Overview of MAC-Based Authentication
Unlike 802.1X, MAC-based authentication is not a standard, but merely a best-practices
method adopted by the industry. In MAC-based authentication, users are called clients, and the
switch acts as the supplicant on behalf of clients. The initial frame (any kind of frame) sent by a
client is snooped by the switch, which in turn uses the client's MAC address as both username
and password in the subsequent EAP exchange with the RADIUS server. The 6-byte MAC
address is converted to a string on the following form "xx-xx-xx-xx-xx-xx", that is, a dash (-) is
used as separator between the lower-cased hexadecimal digits. The switch only supports the
MD5-Challenge authentication method, so the RADIUS server must be configured accordingly.
When authentication is complete, the RADIUS server sends a success or failure indication,
which in turn causes the switch to open up or block traffic for that particular client, using static
entries into the MAC Table. Only then will frames from the client be forwarded on the switch.
There are no EAPOL frames involved in this authentication, and therefore, MAC-based
Authentication has nothing to do with the 802.1X standard.
The advantage of MAC-based authentication over 802.1X is that several clients can be
connected to the same port (e.g. through a 3rd party switch or a hub) and still require individual
authentication, and that the clients don't need special supplicant software to authenticate. The
disadvantage is that MAC addresses can be spoofed by malicious users, equipment whose
MAC address is a valid RADIUS user can be used by anyone, and only the MD5-Challenge
method is supported.
The 802.1X and MAC-Based Authentication configuration consists of two sections, a system-
and a port-wide
