Antaeus TALOS 55, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 53

ANTAEUS TALOS 55
II. PREPARATION FOR OPERATION
A. GENERAL
When unloading and unpacking the vibratory driver, use extreme care. For your protection, make
a thorough inspection of the unit immediately on delivery. In case of any damage or shortage, notify
the transit agent at once and have the delivering carrier make a notation on the freight bill.
B. SAFETY PRECAUTIONS
Safety is basically common sense. There are standard safety rules, but each situation has its
own peculiarities which can not always be covered by rules. Therefore, your experience and
common sense will be your best guide to safety. Be ever watchful for safety hazards and correct
deficiencies promptly.
Use the following safety precautions as a general guide to safe operations:
B. SAFETY PRECAUTIONS
1. Read this manual thoroughly before operating or working on the equipment.
2. Read and follow any safety instructions in the excavator operators manual.
3. Only well trained and experienced personnel should attempt to operate or maintain this equipment.
4. CAREFUL WHEN LIFTING OR CARRYING PILES IN THE VIBRATOR
CLAMP. CLAMP MAY LOSE PRESSURE WHEN UNIT IS NOT VIBRATING.
5. Never adjust, lubricate or repair the unit when it is in operation, or lifted above ground level.
6. Never remove, paint over or cover warning or safety labels. If labels become damaged or
unreadable, replace immediately.
7. All personnel should wear approved safety clothing, including HARD HATS, SAFETY SHOES,
SAFETY GLASSES and HEARING PROTECTION when in the vicinity of this machinery.
8. Do not stand any closer to this equipment than necessary when it is in operation. Parts may loosen
and fall. Never stand under operating, or elevated, equipment.
9. When maintaining or repairing the equipment, never substitute parts not supplied, or approved in
writing, by ANTAEUS.
10. Do not weld, or flame cut, on this equipment.
11. Never use or store flammable liquids on or near the engine.
12. Insure that all lifting equipment, including wire rope, slings, hooks, shackles,
etc., are properly sized for the worst case loads anticipated during operations.
13. If there are any questions about the weights, specifications, or performance of the unit, contact
ANTAEUS, or the excavator manufacturer, before handling or operating the equipment.
14. If the equipment is to be used for anything other than driving or extracting plumb piles, contact
ANTAEUS before using the unit.
15. Check wire rope clips for tightness, and check wire ropes for wear, daily.
II-1