Antaeus TALOS 55, Руководство по эксплуатации и техническому обслуживанию

Страница: 13 / 53

ANTAEUS TALOS 55
II. PREPARATION FOR OPERATION
C. RIGGING OF VIBRATOR (CONTINUED)
3. GAGE HOSE:
It is recommended that a 0-3000 PSI pressure gage be installed, within convenient view
of the excavator operator, for situations when the operator desires to close the Talos 55 clamp,
without starting the vibrator. (See manifold assembly drawing for fitting location).
a. Measure the length of ¼” ID hydraulic hose that will be required to connect the gage fitting, on
the Talos 55 manifold, to the desired gage location. Include enough extra hose length to allow
the full range of motion of the excavator stick and boom. Gage hose pressure rating to be 3000
PSI minimum.
b. Order and install the hoses measured above. Be sure that the hose working pressures match or
exceed the maximum pressure for your specific Talos 55 application. See the first page of this
manual for pressure settings that are specific to your Talos 55.
c. After the hoses are installed, slowly move the Talos 55, and the excavator, through full range of
motion to be sure that hoses do not bind or pull tight.
d. Fasten the non-flexing portions of the hoses to convenient structures on the boom and stick. Re-
check range of motion.
e. To bleed the air from the hoses, loosen the two 0.38” ID hoses at the Talos 55 clamp cylinder
(approx. one turn). With the excavator running at low RPM, move the AUX control joy stick
slightly into the clamp close posi tion. Wait until oil flows from the connection at the hydraulic
clamp (clamp close). When oil flows without air, tighten the connection. Now move the bucket
control joy stick slightly into the clamp open position. Wait until oil flows from the connection
at the hydraulic clamp (clamp open). When oil flows without air, tighten the connection.
4. CHANGING EXCAVATORS
a. NEVER SWITCH THE Talos 55 TO AN EXCAVATOR OF A DIFFERENT MAKE OR MODEL
WITHOUT CONTACTING ANTAEUS. Moving a Talos 55 to a different excavator than it was
designed for can cause serious vibrator damage, or inferior performance. To move a Talos
55 to a different excavator, the following items must be analyzed by ANTAEUS personnel to
insure a correct match to the new excavator;
i. Yoke width
ii. Yoke pin diameter
iii. Hydraulic motor size
iv. Manifold pressure settings
v. Excavator horsepower
vi. Excavator hydraulic system
b. For the convenience of the owner, a Talos 55 application form has been included as page VIII-20
of this manual. If it is contemplated to move the Talos 55 to a different excavator, complete this
form and mail, e-mail, or fax, this form to your local ANTAEUS office.
II-5