Ansult 416120, Руководство по эксплуатации

Страница: 85 / 98

EN
85
the event of a very large energy output,
or when it is cold outside.
• Note that normally the heat pump can
increase the water temperature from 2 to
5°C, depending on the outdoor
temperature.
• In the event of any interference, or if an
error code is displayed, switch off the heat
pump, wait for 5 minutes, and start the
heat pump again.
heat pump to an earthed and fused
circuit in accordance with local
regulations.
• The outdoor unit is supplied with a pre-
heater and heating coil for operation at
low outdoor temperatures. This reduces
wear and ensures a longer lifespan for the
compressor, as well as simplifying
drainage during defrosting. The functions
are regulated electronically in relation to
the outdoor temperature.
• The defrost system is activated
automatically and defrosts the outdoor
unit at suitable intervals, depending on
the outdoor temperature.
• Timer function for starting and switching
off.
• The outdoor unit has acrylic-coated
aluminium fins for optimum run-off and
corrosion protection.
• The heat exchanger is manufactured in
accordance with the latest technology,
with a large surface for optimum heat
transfer.
• Select the correct heat pump output.
The heat pump should normally account
for about 50% of the energy requirement
for heating, and can be connected to
existing systems.
• The heat pump draws energy from the
outside air. The efficiency decreases when
the outdoor temperature drops. It is
therefore necessary to have additional
energy from the existing heating system
when it gets colder outside.
• The maximum water temperature is
50°C, and the highest recommended
temperature is 45°C. Note that the heat
pump cannot reach maximum
temperature without additional energy in