Anslut 007018, Руководство по эксплуатации

Страница: 69 / 70

EN
69
Water level warning
1. When the water level in the collector
tank reaches the specified level the air
conditioner gives 8 audio prompts and
the display shows P1.
2. The air conditioning/dehumidification
stops, but the fan continues to run.
Carefully move the air conditioner to a
suitable drain, remove the bottom plug
and allow the water to run out.
3. Replace the bottom drain plug and start
the air conditioner. P1 disappears from
the display. Contact the retailer if the fault
persists.
FIG. 29
NOTE:
Remember to firmly replace the bottom drain
plug before starting the air conditioner to
avoid leakage.
Remove the air filter
Remove the air filter as shown in the diagram.
FIG. 30
• Clean the air filter every other week for
best functionality.
• Empty the tank as soon as the warning
code P1 is shown. Always empty the tank
before putting away, otherwise there is a
risk of mould accumulating.
• If there are any pets in the house, clean
the grille regularly from hairs that can
block the flow of air.
NOTE:
Never use the air conditioner without a filter
– dust and impurities will reduce its capacity.
Cleaning
Clean the air conditioner with a soft cloth
moistened with a mild detergent. Wipe with a
dry, lint-free cloth afterwards.
Storage
When the air conditioner is not in use:
1. Empty the tank according to the
instructions.
2. Allow the air conditioner to run in FAN
mode for 12 hours in a warm room to
dry the inside and to reduce the risk of
mildew.
3. Switch off the air conditioner and pull out
the plug.
4. Clean the air filter according to the
instructions, allow to dry and replace.
5. Remove the batteries from the remote
control.
NOTE:
Store in a dry and cool place. Do not expose
the air conditioner to heat or direct sunlight,
this can reduce the service-life.
Temperature settings
Mode Temperature range
COOL (cooling
mode) 17–35°C (62–95°F)
DRY
(dehumidification) 13–35°C (55–95°F)
INSTALLATION OF OUTLET HOSE
• The outlet hose and adapter should be
fitted, if necessary for the mode in use.
• The outlet hose must be fitted for COOL
and AUTO mode.
• The outlet hose is not fitted for FAN and
DRY mode.