Anslut 007018, Руководство по эксплуатации

Страница: 66 / 70

EN
66
HOW TO USE
AUTO
1. Press the MODE button until AUTO mode
is activated.
2. Press the TEMP button to set the required
temperature from 17 to 30°C in steps of
1°C or from 62 to 88°F in steps of 2°F.
3. Press the ON/OFF button to start the air
conditioner.
NOTE:
• In AUTO mode the air conditioner
compares the actual room temperature
with the set point temperature, which is
set from the remote control and
activates COOL, HEAT, FAN or DRY mode.
• In AUTO mode it is not possible to set the
fan speed. The fan speed is controlled
automatically.
• You can also set the required mode
manually.
Cooling mode/fan mode
1. Check that the air conditioner is
connected to the mains. Press the
MODE button until the required mode is
activated (COOL, HEAT (only on models
with both heating and cooling) or FAN).
2. Press the TEMP button to set the required
temperature from 17 to 30°C in steps of
1°C or from 62 to 88°F in steps of 2°F.
3. Press the FAN SPEED button to set the
required fan speed to AUTO, LOW or HIGH.
4. Press the ON/OFF button to start the air
conditioner.
NOTE:
In FAN mode the set point temperature is not
shown on display on the remote control and
it is not possible to change the setting. Only
steps 1, 3 and 4 should be carried out.
Dehumidification
IMPORTANT:
When the dehumidification function is not in
use, the drain plugs must be fitted securely
in the outlets. When the dehumidification
function is in use, the drain plugs must be
stored out of the reach of children in order to
avoid the risk of choking.
1. Check that the air conditioner is
connected to the mains. The status light
on the air conditioner goes on. Press the
MODE button until DRY mode is activated.
2. Press the TEMP button to set the required
temperature from 17 to 30°C in steps of
1°C or from 62 to 88°F in steps of 2°F.
3. Press the ON/OFF button to start the air
conditioner.
NOTE:
In DRY mode it is not possible to set the
fan speed. The fan speed is controlled
automatically.
TIMER
Press the TIMER ON button to activate the
setting of start delay. Press the TIMER OFF
button to activate the setting of stop delay.
SETTING THE START DELAY
1. Press the button TIMER ON. The display on
the remote control shows TIMER ON, the
last set start delay, and the status in h.
2. Press the TIMER ON button again to set
the required start delay. Each time you
press the button the setting increases
in steps of 0.5 hours up to 10 hours and
steps of 1 hour from 10 to 24 hours.
3. When the time for TIMER ON is set a
signal is sent to the air conditioner after
0.5 seconds. After another 2 seconds the
h status disappears and the set point
temperature is shown again on the
display.