Anolis ArcPower 16x12, Руководство пользователя

Страница: 19 / 23

1
Use [UP] and [DOWN] buttons to select desired dimmer characteristic and press [ENTER] to confirm.
i.bLi. --- Initial blink . If this function is on, the ArcPower 16x1 makes auto-calibration (LED modules, one by
one, lit on 100% for short time,) after switching it on. During this action the ArcPower 16x12 finds out the load
connected to its LED outputs and makes auto-calibration. If the LED modules will not be changed (still the
same LED modules connected), after first auto-calibration you can set "i.bLi" at Off, as autocalibration takes
some time. In case, that some LED modules will be changed (even the same type) you should perform auto-
calibration again.
In. Po.
- Use the menu to set all effects to the desired positions at which they will stay after switching the fixture
on without DMX signal connected.
dF.SE. --- Default Settings .Select this option to reset all fixture personalities to the default values.
uPd. --- Software update - The menu item allows you to update software in the fixture via either serial or USB
port of PC.
The following are required in order to update software:
- PC running Windows 5/8/000/XP or Linux
- DMX Software Uploader
- Flash cable RS3/DMX No.1305064 (if you want to use a serial port of PC)
- Robe Universal Interface (if you want to use an USB port of PC)
Note1:
Software update should execute a qualified person. If you lack qualification, do not attempt the update
yourself and ask for help your ROBE distributor.
Note 2:
DMX address, programs 1-2 and all items in the menu "SPEC" will be set to their default values.
To update software in the fixture:
I. Installation of the DMX Software Uploader.
1. DMX Software Uploader program is available from the Anolis web site at WWW.anolis.cz.
. Make a new directory ( e.g. Robe_Uploader) on your hard disk and download the software into it.
3. Unpack the program from the archive.
II.Fixture software updating.
1. Determine which of your port is available on your PC and connect it:
- with the DMX input of the fixture if you using the flash cable RS232/DMX
- with the DMX input of the Robe Universal Interface if you using the USB cable.
Disconnect the fixture from the other fixtures in a DMX chain. Turn both the computer and the fixture on. Make
sure the lamp is switched off (only if the fixture involves a lamp).
. Switch the driver to the updating mode:
1 Use the UP/DOWN buttons to find “SPEC.“ menu.
Press the ENTER button.
3 Use the UP/DOWN buttons to select “ uPd.“ item.
4 Press the ENTER button
5 Use the UP/DOWN buttons to select “ yES“ option
6 Press the ENTER button
Note: If you do not want to continue in software update, you have to switch off and on the fixture
to escape from this menu.
3. We recommend to cancel all running programs before start of the Software Uploader.
4. Run the Software Uploader program. Select desired COM and then click on the Connect button.