For WDS-enabled Router setup:
Before Setup: When configured in AP-Router mode, you can enable its WDS function
and allow it to serve as the main WDS base station to which WDS-enabled repeaters
can connect. Please identify the MAC address of your Anker device, printed on the
side of the unit.
f. Click
Finish
to apply the settings. Wait 2 minutes to allow a full restart.
default, the network SSID is named "Anker-Repeater". Then configure the
repeater to match the same channel and wireless security settings as your
router.
Begin standard setup
In the
Quick Installation Guide for AP-Bridge, AP-Router and Client Mode
,
please follow
Steps 1-5
for AP-Router mode with your Anker device configured as
a Router.
1.
Enable WDS
2.
Configure your existing router
2.
Connect to the wireless web
Please refer to
Step 5
of the
Quick Installation Guide for Repeater Mode
to
complete setup.
3.
Logon to the device's configuration page
Open a web browser on your computer, and type 192.168.100.253 to reach
the device's configuration page. When the log-on dialogue is displayed, enter
your default UserName/Password: admin/admin to logon to the configuration
web page of your repeater.
Click
Wireless setting > Wireless basic settings
and select your desired
channel.
2.1
2.2
Refer to your router's instruction manual and enter your router's configuration
page.
For your wireless settings, find the WDS configuration setup page.
Follow your router's instructions, and when prompted – enter the Anker
repeater's MAC address. If your router can automatically scan for available
wireless networks, select your newly named SSID to allow the router to
automatically fill in the MAC.
Click
Finish
or
Save
to apply the settings. Wait 2 minutes to allow a full restart.
2.1
2.2
2.3
2.4
17
