5000M Crusader G Upgrade Installation Guide
P/N 70000549B
All rights reserved. Subject to change without notice.
8
14-February-03
Network Connection Installation
To install the network connection, plug the standard CAT5, 8-pin, RJ-45
connector into the RJ-45 plug located on the back of the console. The
CNC provides access to network drives via Ethernet.
Procedure:
1. Use a standard CAT5, RJ-45 cable for the network connection.
Refer to
Figure 1
.
Network Connection
230002252
Figure 1, Console Rear Panel
Refer to
CNC Network Setup
, P/N 70000483, for an overview of network
setup.
NOTE:
A qualified networking engineer must set up the networking
software. Software varies based on the type of network
operating system used.
