Anest Iwata E-M10C Series, Инструкция по эксплуатации

Страница: 55 / 73

- 11 -
CAUTION
(1) When the situation forces you to clean electrostatic gun with thinner gun, be sure to observe the
following. If not, it can fail electrostatic gun.
a) After cleaning with thinner gun, be sure to blow with air and dry up thinner attached to surface of
electrostatic gun and low voltage cable. As thinner can enter air passage of electrostatic gun during
cleaning with thinner gun, be sure to spray air through electrostatic gun (dry air) and blow remaining thinner
out.
b) Do not spray thinner gun for a long time. Especially do not focus on one spot.
c) Do not spray thinner gun directly to the following spots.
①
Connector of low voltage cable
② Nail of trigger
③ Air hole of air cap
④
Inside of air nipple
(2) What you must never do
Never immerse electrostatic gun body or low voltage cable in cleaning thinner. If done, thinner can enter air
passage and high voltage generator in gun, failing electrostatic gun and electrostatic controller or disconnecting
low voltage cable for a short time due to its deterioration.
Low voltage cable
①
②
③
④