Anest Iwata E-M10C Series, Инструкция по эксплуатации

Страница: 49 / 73

- 5 -
4. Connection and setting
< For Supervisor >
4.1 Connection of electrostatic gun
Before connecting electrostatic gun, be sure to read and observe the below chart. In case of E-M15C
series, refer to “standard connection example of (1) E-M15C series” on page. Refer to “standard
connecting example of (2) E-M10C series” on page 8 for E-M10C series gun and then install the gun.
WARNING
Before connection, be sure to turn off primary side electric source, release primary side air source
and turn off all electric source switches. (Refer to P.
④
”avoidance of wrong operation”)
Be sure to check that all products are grounded. If not done, it can cause fire by spark
discharge through leakage or charge and bodily injury by electric shock.
(1) Be sure to use designated primary side electric source for electrostatic controller (E-SC12
(-FM) series
：
option). Input of different voltage other than designated one can cause damage
to the product or fire (refer to instruction manual of electrostatic controller or multi-gun control
system as for details).
(2) Max. air pressure of primary side air source must be less than 0.68MPa. If higher, it can
cause damage to the product or accident since the product is not for high pressure.
CAUTION
(1) Be sure to clean air filtered through air dryer, air filter (3
〜
5
μ
m) and oil mist separator (0.03
〜
0.01
μ
m).
When using lubricator in air supply piping, take air from separate supply piping or filter through over two-stage
oil mist separators. Dirty air for painting can fail painting.
(2) When using for the first time after purchase, spray thinner into the inside of fluid passage and remove
anti-rust oil. Remaining anti-rust oil can fail painting such as fish eyes.
(3) Before connecting air hose to electrostatic gun, fully blow air. Dust in piping can fail painting.
(4) Before use, filter paint to remove dust or foreign matter from paint. If not, it can cause leak from seated
section and make initial fluid output unstable.
(5) Electrically connect electrostatic controller (E-SC12(-FM) series ： option) and other equipment in accordance
with this instruction manual and instruction manuals of other related products.
(6) Bind low voltage cable, air hose and fluid hose so that there is no partial tension or bend. Refer to (4.2
“Precautions on installation and handling of low voltage cable” (P.6)