Anest Iwata E-M10C Series, Инструкция по эксплуатации

Страница: 61 / 73

- 17 -
6. Disassembling and assembling
< For Supervisor >
Only the supervisor and / or other equally qualified personnel, having fully read and understood
the contents of this instruction manual, can take care of matters related to Chapters 6.
WARNING
Before disassembling, be sure to turn off electric source of electrostatic controller (E-SC12(-FM) series:
option) , and fully release air pressure and fluid pressure.
CAUTION
Precautions when disassembling and assembling electrostatic gun
(1) First fully remove attached dust on each part before assembling.
(2) After assembling, be sure to check that there is no leakage of air or fluid.
(3) Over-tightening air cap, fluid nozzle and plastic screw at gun tip can damage screw or seated section.
Pay attention not to tighten with more than necessary strength.
(4) Be sure to fit or remove fluid nozzle while pulling trigger. If not, it can damage seat of set.
6.1 How to replace fluid needle set and fluid needle packing
(1) Remove air cap and fluid nozzle
Job-1 Manually turn air cap cover and remove air cap cover and air cap.
Job-2 Apply monkey wrench to hex. Surface of fluid nozzle while pulling trigger, and loosen screw and
remove.
(2) Remove fluid needle bar
Job-1 Remove locked fluid adj. knob.
By hand
By hand
Cap cover
Air cap
Spanner
Keep trigger pulled
Fluid nozzle
Fluid adj. knob