Anest Iwata DPS-120LB, Инструкция по эксплуатации

Страница: 42 / 54

- 39 -
No.
Problems Causes Remedies
③
Paint contains air.
①
Intake filter and long nipple are loose.
①
Tighten and secure connection.
②
Lower adaptor is loose.
②
Tighten.
③ Diaphragm is damaged. ③ Disassemble, inspect, replace ☆
④ Nut to hold diaphragm is loose or
O ring is damaged.
④
Disassemble, inspect, replace
☆
⑤ Seat packing is deformed or damaged. ⑤ Disassemble, inspect, replace ☆
④
Paint leaks.
①
Connection is loose.
①
Assemble again.
☆
②
Seat packing is deformed or damaged. ②
Disassemble, inspect, replace
☆
⑤
Air leaks.
①
Air operating valve is not fitted
properly.
①
Tighten and fit correctly.
②
Lid is not fitted properly.
②
Assemble again.
☆
③ Diaphragm is not fitted well. ③ Assemble again. ☆
⑥
Pump operates
but paint does
not come out. ① Intake filter is clogged. ① Clean filter.
② Inside of intake filter set is clogged. ② Disassemble, inspect, replace ☆
９−２
. Fluid regulator
No.
Problems Causes Remedies
①
Pointer of pressure
①
Seated section is not properly contacted.
①
Disassemble, inspect, replace.
☆
gauge points at
max. level.
②
Seated section is scratched or damaged.
②
Disassemble, inspect, replace.
☆
③ Packing is scratched or damaged. ③ Disassemble, inspect, replace. ☆
②
Paint leaks
①
Loose bolt.
①
Tighten and connect correctly.
outside.
②
Loose hex. nut.
②
Tighten and connect correctly.
③
Diaphragm is damaged.
③
Disassemble, inspect, replace.
☆
④
O ring is damaged.
④
Disassemble, inspect, replace.
☆
③
Pressure does not
① Pump pressure is low. ① Increase air pressure.
increase.
②
Failure of pressure gauge
②
Disassemble, inspect, replace.
☆
③
Paint clogs in riser pipe.
③
Disasseble, inspect, clean or replace
☆