ANEP BOX-C, Руководство пользователя

Страница: 12 / 24

ANEP BOX-C Version #1 09/22/2014
12
3.5 - Enabling and adjustment of parameters
3.5.1 - Conversation Timeout
Conversation timeout from 1 to 99 minutes (factory default = 3 minutes)
En mode programmation :

Enter the sequence : # 2 0 1
Then enter the conversation timeout (from 1 to 99) followed by « # »
3.5.2 - Listen to call identification
In programming mode :

Enter the sequence # 105

Enter the phone number for receiving data by the central reception with a FT 2008 , FT
1001 or FT 4004 modem and software ANEPCENTER® or compatible frontal.

Press the key « # »
A «site record» must first be established in the software ANEPCENTER®
(refer to the manual ANEPCENTER®)
During programmation mode exit, BOX-C performs a periodic call immediately
NOTE: During cyclic call, the central (AnepCenter or compatible) receiving the call can
reprogram the clock of the C-BOX.
3.5.3 - Cyclic test / Periodicity
In programming mode :

Enter the sequence # 301

Dial the number of days for the periodicity of the cyclic call 1, 2 or 3.
Default: 3 days. example: 2 days = 301 # 2 #
3.5.4 - Listen data transfer
To enable the technician working on the lift to know that the C-BOX module is in communication with
a reception central, all data exchanges are audible (low level).
NOTE: access to the programming mode is not possible during a phone call.