Anderson Group
Double Stretcher – Operator’s Manual
25
6
Adjusting during the wrapping of the first
bale
For the first bale you have to verify and correct if needed the way that the plastic film sets in
the plastic cut and hold so as to give you a well wrapped bale.
Warning!
When you operat e the wrapper in manual mode, it
is pos sible tha t the foldi ng arm comes in contac t
with the receiving table of the wrapper. T o avoid
this type of contact be sure that you raise the arm
before making the table turn.
Follow this procedure to adjust the position of the plastic film in the cut and hold:
1.
Manually wrap a bale with a few layers of plastic.
2.
Press the button
Pause (3 )
o n the remot e of the wrapper to st op the wrappi ng
cycle.
3.
By using the lever for turning the table of the wrapper (Figure 11), turn the table (in
the same direction as in remote mode) and put the wrapper i n the position as if it
were to be ready to unload the bale (the rolls should be perpendicular to the frame).
Figure 11 – Control lever to turn the table manually
