Anderson Group
Double Stretcher – Operator’s Manual
21
5
Installing the plastic roll
When the wrapper is equipped with th e double stre tcher, th ere are two coa ts of plastic fi lm
applied at t he same time. Y ou should always load the s tretchers with new rolls of plastic so
that they will empty at the same time and you can replace them at the same time.
NOTE :
The plastic film may soften if it is left in the sun for a long
period of time. Thi s may make t he pl astic st retch more
and create holes in the wrapped bales. Please make sure
to store y our p lastic film in a dry area away from direct
contact of the sun.
NOTE :
It i s easi er to mak e adj ustments t o t he do uble st retcher
before installing the p lastic film ro ll. I t is t hus
recommended you make adj
ustments beforehand by
following the instructions in section 4.
To install the plastic film roll on the double stretcher proceed as follows:
1.
Open the plastic cut and hold by pulling on the round button (lever) situated over the
control levers for the wrapper (see Figure 7).
Warning!
Before continuing, make sure to turn off the engine
of the wrapp er to avo id injury and accidental
activation of the components of the wrapper.
NOTE :
Both p lastic cu t and hold systems are on th e same
hydraulic circuit. Thus they work at the same time.
