3
1-3 Specifications
Battery mass
Approximately 1.3 kg
Operating temperature range
+5
°
C to +40
°
C (+41
°
F to +104
°
F)
Storage temperature range
-20
°
C to +40
°
C (-4
°
F to +104
°
F)
Operation hours
Approximately 8 hours (when operated continuously using a GX
series balance. Operation hours depend on operating conditions.)
Charging time
Approximately 15 hours
Charging method
Charge with timer function for an automatic stop
External dimensions
58 (H) x 96 (W) x 140 (D) mm
Output voltage
12 V (500 mA max.)
Battery type
Nickel-metal-hydride (Ni-MH) battery
Output cable length
Approximately 1 m
1-4 List of Applicable Balances
Use the AD-1682 only with balances listed below.
Balances
Continuous operation hours
(Depends on operating conditions)
HX series
5 hours
GP series, GX-K/GF-K series
6 hours
FC series, FP series, GH series, GR series, GX/GF series,
HM series, HP series, HR-202, HR-300, HR-
i
series
8
hours
ET-W series, HF series, HR-60, HR-120, HR-200
16 hours
EK-G series, EK-H series, EW-G series
28 hours
HC series, HD series
66 hours
The AD-1682 can be used for other instruments than balances as shown below.
Instruments
Continuous operation hours
(Depends on operating conditions)
SV series (Viscometer)
5 hours
AD-8922 (Remote controller)
12 hours
Note
In this manual, "balance(s)" refers to the A&D-manufactured products listed in the tables above.
1-5 Notes on Using the AD-1682
The continuous operation hours depend on the operating conditions.
The battery, while it is being charged, will not supply power to the balance.
Do not short-circuit the output plug.
The battery may self-discharge while it is left unused for a long period of time. Charge the
battery after a long period of non-use.
The balance, after the display is turned off using the ON/OFF key, is still consuming power. To
turn the power off completely, disconnect the charger from the battery and turn the power
switch to the “CHARGE” position. (If the charger is connected to the battery under this
condition, the battery will start charging.)
Every time the power switch is turned to the “CHARGE” position with the charger connected to
the battery, the battery will start charging. Charging the battery before it is completely
discharged will shorten the battery life.
