9
OUTPUT 1
OUTPUT 1
OUTPUT 2
OUTPUT 2
BATTERY
BANK #1
BATTERY
BANK #1
BATTERY
BANK #2
Battery Temperature Sensor Connection
This unit is equipped with a pair of RJ45 “telephone jack” connectors to serve as connections
for up to 2
Analytic Systems
battery temperature sensors. If only 1 sensor is being used, it
must be plugged into ‘BATT 1” port. This sensor communicates the temperature of the battery
to the charger, and is required for the voltage temperature compensation function, over
temperature shutdown and user-initiated equalize cycle.
There are multiple ways to install the sensor at the battery. Regardless of which method you
use, the sensor must be firmly secured to the battery. The sensor should not lose physical
contact with the battery at any point in the charging cycle.
Pictured:
Analytic Systems
Battery Temperature Sensor
Connect the battery bank(s) to the terminals using an appropriate gauge of wire for the charg-
ing amps. Ensure that the total average load connected to the batteries does not exceed the
unit’s charging amps. See
Specifications
for this unit’s charging amps.
This connection can support up to 2 battery banks. Hook up the battery bank(s) as shown below.
If you are hooking up 2 battery banks keep in mind that they MUST share a common ground!
To install the sensor at the battery,
you may:
• Slide the sensor so it is flush
between the side of the battery and
battery platform.
• Place the battery on top of the
sensor to hold it in place.
• Apply a small amount of silicone RTV
sealant to the sensor and stick it to
the top of the battery.
Single Bank Connection
Dual Bank Connection
