ANALOX ADM Aspida, Руководство пользователя

Страница: 18 / 45

ADM & Sub Aspida
User Manual
Int. Approved
Document ref: PSA-811-22 March 2020 Page 18 of 45
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
6.5 Screen saver
The screen saver function is intended to extend the battery life of an Aspida and reduce screen
burn-in. If the user does not operate any buttons for one minute then the screen saver, when
enabled, will automatically dim the display.
Pressing any button will wake the device from screen saver mode.
If the device is connected to the charger or connected to a PC via USB, the screensaver will not be
shown, but the display will still dim as normal.
During screen saver mode, gas values are still monitored as normal. Any gas alarm will wake the
display from screen saver immediately and the main gas display will be shown.
It is possible to enable/disable the screen saver option via the supplied PC software.
6.6 Battery status
The battery status icon is shown in the top right-hand corner of the display. This icon gives a
representative indication of the power remaining in the batteries. As the batteries run down from
full to empty, the battery icon will be displayed in various states.
Icon Battery status
,
Battery sufficiently charged
Battery low
(flashing)
Battery nearly empty. Approx. 1 hour of operation
remaining. A reminder beep will sound periodically.
The device is powered from the mains charger. The icon
will be shown next to the battery icon.
The device is attached to and powered by a computer via
a USB cable. The USB symbol will be shown instead of
the battery icon (in addition to, if charging).
NOTE: DUE TO THE NATURE OF THE BATTERY TYPE, THE BATTERY
STATUS ICON MAY TEMPORARILY INDICATE A CAPACITY
HIGHER THAN THE TRUE REMAINING BATTERY CAPACITY
UPON SWITCH-ON. THIS EFFECT IS USUALLY SEEN IN
DEVICES WHICH HAVE BEEN SWITCHED OFF FOR AN
EXTENDED PERIOD OF TIME. THE TRUE BATTERY STATUS
WILL BE INDICATED WITHIN A FEW MINUTES OF POWER-UP.