O2 EII Pro
Technical Manual
Document ref: MO2-865-00
December 2015
Page 9 of 26
3
Setting up your O2 EII Pro
NOTE: ON OPENING YOUR O2 EII PRO YOU WILL HAVE TO FIT THE O2
SENSOR.
3.1
Fitting the O2 Sensor
1.
Remove the contents and take the sensor out of the packaging and carefully cut
open the antistatic bag to obtain the sensor. Allow the sensor to settle for 24hr prior
to use.
2.
Loosen the 4 screws located on the front cover. The gasket seal is designed to prevent
water leaking into the O2 EII Pro as a result the seal may be tight. Loosen the seal
by moving the lid from side to side, and then and carefully lift the cover.
3.
Screw the sensor to the inside of the front cover tightly.
