O2 EII Pro
Technical Manual
Document ref: MO2-865-00
December 2015
Page 10 of 26
4.
Connect the JST cable connector to the JST header on the PCB of the O2 Sensor.
5.
Replace the cover carefully taking care that the sensor locates properly and that you
do not trap any wires. Screw down until you feel the gasket tighten; do not over
tighten the screws.
Your Oxygen Analyser is now ready to take a reading.
CAUTION: IF AFTER HANDLING THE SENSOR YOUR FINGERS OR OTHER PARTS
OF YOUR BODY FEEL SLIPPERY OR STINGS WASH WITH A LOT OF WATER. IF
STINGING PERSISTS GET MEDICAL ATTENTION! REFER SECTION 7.0, SAFETY
INFORMATION.
