18
VIO 4K TPP PROGRAMMER'S GUIDE FOR v02.00.7X
3.4
Switching on manual commutation mode
3.4.1
Usage
By default, the inputs’ commutation is done immediately once a TPP commutation related command is
received. With the manual commutation mode, it is possible to do a macro sequence with the commands below
and apply all when the user requests it.
The commands which are associated with the commutation mode, are:
o
PE_INPUTNUM: Change the current input;
o
PRESET_VIEW_BANK_RECALL_REQUEST: Load the view from memory to an input;
o
PRESET_VIEW_BANK_ACTIVE_RECALL_REQUEST: Load the view to the active input;
o
PRESET_BANK_RECALL_REQUEST: Load the preset from memory.
User must particularly be careful with this mode if multiples remote controllers are connected. Multiple
controllers using those commands simultaneously would cause unpredictable results. This can cause
intermixing commands with 2 simultaneously sending controllers.
3.4.2
Detailed commands sequence
Select the manual mode: This command disables the automatic commutation by writing the value 0.
Syntax :
0PCpum
L
F
OR
Select the auto-apply mode: This command enables the automatic commutation by writing the value 1.
Syntax :
1PCpum
L
F
Apply modification in manual mode: This command allows the application of sent previous commands
to commute.
Syntax :
1PCrpr
L
F
Answer:
0PRrpr
C
R
L
F
CIava0
C
R
L
F
CIava1
C
R
L
F
Syntax:
CIava
<value>
C
R
L
F
The COMMUTATION_AVA register indicates that the commutation is running by the value 0 and finished
by the value 1.
