Evaluation Board User Guide
UG-061
Rev. 0 | Page 5 of
QUICK START
The flowchart shown in Figure 3 outlines the initial steps to set
up the evaluation board and associated communication circui-
try. Step-by-step instructions on how to perform each step in
this flowchart are provided in the following sections of this user
guide. When the procedures in Figure 3 have been followed and
the evaluation board is operational, the energy metering IC can
be evaluated using the accompanying LabVIEW evaluation
software.
STEP 1: INSTALL THE DRIVERS.
REFER TO THE INSTALLING
THE DRIVERS SECTION.
STEP 2: POWER THE EVALUATION BOARD.
REFER TO THE CONNECTING THE
EVALUATION BOARD SECTION.
STEP 3: RUN THE EVALUATION SOFTWARE.
REFER TO THE EVALUATION BOARD
SOFTWARE SECTION.
SET UP
COMPLETE
08600-
003
Figure 3. Quick Start Flow Diagram
Содержание UG-061
Страница 28: ...UG 061 Evaluation Board User Guide Rev 0 Page 28 of PCB LAYOUT COMPONENT SIDE 08600 055 Figure 52 Layer 1...
Страница 29: ...Evaluation Board User Guide UG 061 Rev 0 Page 29 of PCB LAYOUT SOLDER SIDE 08600 056 Figure 53 Layer 2...
Страница 31: ...Evaluation Board User Guide UG 061 Rev 0 Page 31 of 3 NOTES...
