Analog Devices Dust Networks DC9004B, Руководство пользователя

Страница: 14 / 19

14 A
NALOG
D
EVICES
, I
NC
. C
ONFIDENTIAL
DC9006A
AND
DC9004B U
SER
G
UIDE
In order to use the Tag-Connect TC2050-IDC cable, a surface mount footprint
located on the customer board shall match the following pin numbering.
VSUPPLY
GND RESETn
CLI_TX
CLI_RX
IPCS_MOSI
IPCS_SCK IPCS_MISO
FLASH_P_ENn
IPCS_SSn
Figure 8 Tag-Connect Programming Footprint
JTAG and SWD Interfaces (2x5 2mm” pitch header)
The following table describes the pinout of the JTAG P6 (MOLEX/878321020).
Pin # Signal Direction Pin # Signal Direction
1 TCK O 2 GND O
3 TMS O 4 TDO I
5 GND - 6 TDI O
7 GND - 8 RESETn -
9 VSUPPLY - 10 NC -
Signal direction is relative to the Programming Adapter board.
The following table describes the pinout of the SWD (“Single Wire Debug”) P4
(SAMTEC/FTSH-110-01-L-DV-K-P). P4 is intended to be used in conjunction with
the TC2030-CTX-20 cable from Tag-Connect, described in http://www.tag-
connect.com/TC2030-CTX-20 .
Pin # Signal Direction Pin # Signal Direction
1 NC (VCC) - 2 TMS (SWDIO) O
3 GND - 4 TCK (SWCLK) O
5 GND - 6 TDO (SWO) I
7 NC - 8 TDI O
9 GND - 10 RESETn -
1 NC - 12 NC -
3 NC - 14 NC -
5 GND - 16 NC -