Analog Devices ADSP2192-12 EZ-KIT LITE, Руководство пользователя

Страница: 8 / 50

ADSP2192-12 EZ-KIT Lite Evaluation System Manual
1-1
1 INTRODUCTION
Thank you for purchasing the ADSP2192-12 EZ-KIT Lite

evaluation kit. The evaluation board is
designed to be used in conjunction with the VisualDSP
++

development environment and is based
on the ADSP2192-12 fixed-point digital signal processor (DSP). The kit is shipped with an
evaluation board and the Vi+ software. Using the EZ-KIT Lite in conjunction with the
Vi+ environment and the debug monitor running on the EZ-KIT Lite evaluation board
gives users the ability to perform advanced application code development and debug such as:
•
Create, compile, assemble, and link application programs written in C and ADSP-219x
assembly
•
Load, run, step in, step out, step over, halt, and set breakpoints in application programs
•
Read and write data and program memory
•
Read and write core and peripheral registers
•
Plot memory
Access to the ADSP2192-12 processor is achieved via the PC through the PCI bus communicating
with the debug monitor or an optional JTAG emulator. The JTAG emulator allows the PC to
perform in-circuit emulation through the processor’s JTAG interface. JTAG emulators perform
debugging at a much faster rate and provide many advanced debug features that are not available
with the ADSP2192-12 debug monitor. JTAG emulators can be purchased separately from Analog
Devices.
The board’s features include:
•
Analog Devices ADSP2192-12 DSP running at 33 MHz
•
Analog Devices AD1885 AC’97 SoundPort
®
codec
•
Jumper Selectable Line-In or Mic-In via 1/8” Stereo Jack.
•
1/8” Stereo Jack for Headphone Out
•
Socket for Optional Serial EEPROM
•
PCI version 2.2 Compliant Interface
•
USB version 1.1 Compliant Hardware Interface with Connector
•
Selectable PCI (Plug-In card) Operation, USB Operation (optional), or
Stand-alone Operation (optional)
•
Two pushbuttons for GPIO inputs
•
Two user programmable LEDs
•
14-Pin Connector for JTAG Emulator Interface
•
User Installed expansion header
•
Small (2.5” x 3.5”) breadboard area with typical SMT footprints provided
www.BDTIC.com/ADI