Analog Devices ADSP2192-12 EZ-KIT LITE, Руководство пользователя

Страница: 14 / 50

ADSP2192-12 EZ-KIT Lite Evaluation System Manual
2-3
10. Turn on the computer and verify that the green PCI LED on the bracket of the EZ-KIT Lite
turns on. This indicates that SW4 is in the correct position and that the board is successfully
being powered by the computer’s PCI bus.
11. Once the PC is running, Windows should detect new hardware and request the appropriate
drivers for the board. Please refer to “Installing PCI Drivers” section of the “Installing the EZ-
KIT Lite Software” below.
This completes the hardware installation.
2.4.2 Installing the EZ-KIT Lite Software
2.4.2.1 Installing PCI Drivers
You must install the drivers prior to using the PCI interface with the Vi+ debugger. The
next few sections will walk you through installing the proper driver for your system.
2.4.2.1.1 Installing the Windows 98 Driver
Upon rebooting your PC, the Windows 98 Add New Hardware Wizard dialog box should appear.
If it does not, manually run it by hitting the Start button on the Windows taskbar. Then choose
Settings and Control Panel . Double-click on the Add New Hardware icon.
1. The wizard should detect the EZ-KIT Lite as shown in figure 2-1. Click Next to continue.
Figure 2-1: Windows 98 Add New Hardware Wizard detected the EZ-KIT Lite.
2. Select Search for the best driver for your device as shown in figure 2-2. Insert the
Vi+ CD into the CD-ROM drive and click Next to continue.
www.BDTIC.com/ADI