Anakin Club Racer SKY-HERO, Руководство пользователя

Страница: 12 / 35

12
In order to make fine adjustments to your camera angle, it may be necessary to slightly ream out (deepen
the size of) the grooves in the adjustable lower camera plate (this can be done using a small file or drill)
NOTE: You can remove the camera at any point to adjust its position by slightly unscrewing the two
bolts holding the curved bracket above the camera
Using double sided adhesive tape, position the CC3D flight controller in the middle of the upper frame
and 10mm back from the edge of the 2nd hole in the upper frame and connect the 4 wire (Black, Red,
Blue and Yellow) CC3D cable to the “Main Port” of the CC3D
NOTE: with the CC3D label facing upwards the black wire of the connector should be on the left side
of the main port as you push it in.
45°
45°
37,5°
30°
CAMERA SETUP