Amylior LOGOSILVER OUTCHAIR L, Руководство пользователя

Страница: 57 / 76

P·57
The activation of one of these switches affects the driving performance of the chair. Return
the seat to its upright position, make sure that the seat incline is horizontal, retract the
casters and check that the problem is resolved.
9.2. SOLVING COMMON PROBLEMS
Problems Diagnostic Solving
Centering the
Joystick: The Joystick is off
center before and
during the switching
on of the control
system. Make sure the joystick is centered and turn on
the control system. It is better not to touch
the joystick when it is being
switched on.
Low Battery The battery voltage is
less than 16 V. Check the condition of the batteries and the
connections to the control system.
High battery voltage The battery voltage
exceeds 35V.
Check the condition of the batteries and the
control system connections.
Brake failure Problem with the
magnetic breaks or
their connections. Check magnetic brakes, cables and connections
to the control system.
Check that the engine brake is not disabled
(see section 7.4 Manual movement).
Engine failure The engine has been
disconnected. Check the motor, cables and connections to
the control system.
Active Inhibition One of the inhibitor
switches is locked and
active. Restart the power. This will reset the lock
mode, which can resolve the error.
Check all cables and switches connected to
the inhibitor input indicated.
Standby The control system
enters sleep mode. The control system enters sleep mode when
it has been idle beyond the Standby time set.
Charging A charger is
connected. Disconnect the charger from the wheelchair.
Incorrect wiring A fault in the wiring
between two
modules. Check the continuity of all cables and
connections as well as for the absence of
pinch points.
If a cable appears visibly damaged, replace it
and restart the armchair cable.
Contact your service agent to obtain a
replacement cable.