AXlink Command Structure
31
AMX Lighting PROlink/AXlink Programming
Recording Commands
These commands send preset data to the AMX Lighting controller memory chip. All recording and
setup commands are stored in non-volatile memory. These commands are also used to store presets,
assign presets for dry closure recall, and erase stored presets.
Recording Presets
If the value for <t> is not entered, the AMX Lighting controller will use the value specified by the
Default Preset Time. The <t> parameter is optional.
Status Commands
Status commands allow a user or a program to get data from the lighting system and to act on that
information.
Retrieving the Current Preset status (feedback)
AXlink channels 1 through 128 are linked to the active status of the 128 presets. Presets are
mutually exclusive. If preset #1 is active, AXlink channel #1 is active.
Retrieving a Dry Closure PUSH/RELEASE status
AXlink channels 147 through 154 are linked to the active status of the 8 dry closure inputs. Each
closure has an independent status. This input section of the AMX Lighting controller can act in a
similar manner to an Input8 card.
Format:
SEND_COMMAND LTS, 'SP<s>T<t>'
Variables:
• <s>: This is the preset number
• <t>: This is the ramp rate, 0-255 in seconds
Example:
SEND_COMMAND LTS, 'SP1T3'
PROlink response:
NO RESPONSE
Format:
AXlink channel 1..channel 128
Example:
[PANEL, 100] = [LTS, 1]
PROlink response:
C
GOTO 001 IN 003
Format:
AXlink channel 147..channel 154
Feedback:
[PANEL, 128] = [LTS, 147]
PUSH example:
PUSH [LTS, 147]
PROlink response:
C
GOTO 001 IN 003
RELEASE example:
RELEASE [LTS, 147]
PROlink response:
NO RESPONSE
Example 2:
[LTS, 147] = (MOTION_DETECTED)
This action associates a channel state with a variable action. In this case, if
motion is detected then it turns channel 147 On.
AXlink response
PUSH [LTS, 147]
PROlink response:
C
GOTO 001 IN 003
Содержание ProLink PRO-DP8
